REMOTE CONTROL GUIDELINES
REMOTE CONTROL PANEL
OPERATION OF REMOTE CONTROL
- key: In standby mode, press key and the machine runs at the speed of 0.6 mph. Press key again and the machine stops. (i.e. another start/stop cycle begins)
- + key: Each time when you press the “+” key during operation, the speed per hour will be increased by 0.2 miles; long press the “+” key to continuously increase the speed by 0.2 miles. Additional function: Press the “+” key for 10 seconds to clear the lubricating icon when the machine is in standby mode.
- – key: Each time when you press the “-” key during operation, the speed per hour will be decreased by 0.2 miles; long press the “-” key to continuously decrease the speed by 0.2 miles.
Note: The speed can only be increased up to 3.8 mph via the remote control. To increase to 7.6 mph, you need to press “+” key on the keyboard.
Note: Make sure that the safety lock switch of the instrument is magnetically on before use, otherwise the machine cannot be started.
- After power-on, the digital tube lights on both sides flash from outside to inside and bottom to top, then the machine enters the standby state.
- Aim the remote control at the signal receiver of the display screen, and press the key on the remote control. The digital tube lights on the display show three bars from bottom to top. The machine starts running at the speed of 0.6 mph.
https://manuals.plus/urevo/ur9tm0011-2-in-1-under-desk-treadmill-manual#ixzz7rB0dXivN